When i get the mat and control box later in week (it went home in trailer with kevin as i had to go to cardiff) i will check it over and see if anything is off. However the two loops span the full width and are sequential one after the other.
see the census manual at
http://identec.com/manuals/appendices.pdf
Mark and i did discuss it and wonder if we can tweak the loops to improve it or somehow space them apart more, but that would mean two mats since getting wider rubber matting is impossible unless you pay exorbitant prices. there is also the problem of transportation and storage.
Comparing results with say Blackbushe (wing 4 dropped in 286) the mat was far worse at Curborough (wing 11 dropped in 378)
The only difference i can see is that the mat had the gantry tripods on it and also had power cables adjacent to it for the lights. Shenington also had high dropped laps and also had gantry/lights.
Given how the system works, i suspect for the fastest cars it may be getting near to its limit and any additional interference from mains hum won't help. after rechecking the manual it does state to keep the loops away from metal so think that's the first and easiest option.
There is also a mention that PC monitors can radiate interference at 100kHz which is very close to the tag frequency. None of us have considered this and whilst the timing screen in the trailer wasn't that close it may have been close enough, since it states in the manual make sure PC monitors are 1.5M x reading range away and suggests 4.5M for a 2M square loop.
Note at blackbushe the monitor was further away and we had fewer drops - conicidence or is that the problem.
Digging deeper. For speeds up to 30mph the loop width should be 2.5M, it also states that no single side of teh loop should exceed 4M.
We have 1M wide x 7M long although identec did think we would be ok. We may need to reconfigure back to the old layout but that brings its own problems.
Unfortunately the drops weren't consistant enough for us to say its one particular issue. We may need a bit of tech help from identec, maybe even a trip to their factory with the kit and a car to let them see how ot works.